ARRI L7-C LE2 LED Pole-Operated Fresnel without Cable (Silver/Blue)

The silver/blue, pole-operated L7-C LE2 Color LED Fresnel without Cable is part of ARRI's continuing effort to replace traditional Fresnels with powerful LED versions that offer unprecedented color control. The L7-C LE2 shares many characteristics with its predecessor, but the most obvious improvement is a 25% boost in power, increasing the light's tungsten equivalency from 750 to 1000W. The key characteristic of any Fresnel is flood-to-spot capability, and the L7-C LE2 meets and exceeds expectations with an impressive beam angle of 15-50°. There's no learning curve when swapping out L7-C LE2 fixture for fixture with standard Fresnels. In fact, you're not going to be moving them around or juggling scrims in high places thanks to the 100-0% on-board dimming. The L7-C LE2 is a "fully tune-able" white light source, allowing you to match existing fixtures from a warm 2800K to an ice blue 10,000K. The on-board controller allows manual intensity control as well as color temperature and +/- green. Specific color shades and skin tones can be matched through the full gamut with the color mixing feature. All functions can be controlled via DMX, an ideal feature for broadcast studios. The hybrid cooling system allows for cooling both actively (with a fan) or passively (without a fan) for times when the set needs to be dead quiet. The L7-C LE2's 1000W equivalent output draws only 160W during normal operation, making possible a savings of a 75% over similar output tungsten lights. And low heat means lower AC bills in the studio. You can actually run nine L7-C LE2's from a 20A, 120 VAC outlet as opposed to two 1000W or three 650W standard fixtures. Meant to be hung overhead on a pipe or grid, this version of the L7-C LE2 has a pole-operated yoke with pan and tilt adjustments made from below with a long (optional) pole. The light does not come with a power cable so you will need to purchase it separately to meet your region's requirements.

Attributes and Benefits

L7-C LE2 with Light Engine 2 are 25% brighter than previous versions Fully tuneable from 2800-10,000K Plus/Minus green correction Vibrant color selection (RGB+W color gamut) Hue and saturation control High color rendering Low power consumption (160W nominal) Fully dimmable True Fresnel lens light characteristics from LEDs Onboard DMX In and Out RDM implementation USB Mini connection for firmware updates Available in blue/silver and black Fan mode selection

ARRI Mains Cable powerCON TRUE1 Top with Bare Ends (5')

The 5' Mains Cable powerCON TRUE1 Top with Bare Ends is a power cord for lights in the ARRI Orbiter Series. This "bare ends" version requires a user-selected plug.