Lighting

The Silver/Blue, Pole Operated L7-C LE2 Color LED Fresnel with powerCON Cable is part of ARRI's continuing effort to replace traditional Fresnels with powerful LED versions that offer unprecedented color control. The L7-C LE2 shares many characteristics with its predecessor, but the most obvious improvement is a 25% boost in power, increasing the light's tungsten equivalency from 750W to 1000W. This pole-operated version is meant for overhead mounting on pipe lengths or a grid. Pan, tilt, and focus are controlled from below with an optional pole using the 3 corresponding cups on the unit's special yoke. The key characteristic of any Fresnel is flood-to-spot capability, and the L7-C LE2 meets and exceeds expectations with an impressive beam angle of 15-50°. There's no learning curve when swapping out L7-C LE2 fixtures for fixtures with standard Fresnels. In fact, you're not going to be moving them around or juggling scrims in high places thanks to the 100 - 0% on-board dimming. The L7-C LE2 is a "fully tune-able" white light source too, allowing you to match existing fixtures from a warm 2800K to ice-blue 10,000K. The on-board controller allows manual intensity control as well as color temperature and +/- green. Specific color shades and skin tones can be matched through the full gamut color mixing feature. All functions can be controlled via DMX, an ideal feature for broadcast studios. The hybrid cooling system allows for cooling both actively (with a fan) or passively (without a fan) for times when the set needs to be dead quiet. The L7-C LE2's 1000W equivalent output draws only 160W during normal operation, making possible a savings of a 75% over similar output tungsten lights. And low heat means lower AC bills in the studio. You can actually run 9x L7-C LE2's from a 20A, 120VAC outlet as opposed to two 1000W or three 650W standard fixtures. Learn More

The 82.7" Kupo Kupole, in a silver anodized finish, is a spring-locking, ceiling-to-floor or wall-to wall pole system with an adjustment range of 82.7 to 145" that can be set up in seconds with a flip of its handle. Made of sturdy aluminum, steel, and rubber, this Kupole is ideal for constructing on-the-fly seamless background setups, temporary shooting structures, or monopod light stands. Learn More

. Learn More

The M18 is an 1,800 W open face lamphead, combining the Academy Scientific and Engineering Award-winning lens-less optical technology of the ARRIMAX with the innovative True Blue design. The result is an extremely powerful lamphead, as small as a 1,200W PAR but with a 70 % higher light output. The M-Series M18 fixture is adjustable from 20° to 60° without requiring spreader lenses. The M-Series M18 Max Set features a 1,800W Lamphead (virtually the same size as a 1,200W lamphead but more than 70% brighter) which runs from most domestic sockets world-wide, a cross-cooling mechanism that allows for safe operation at any tilt angle, protection class IP23 and a true blue tilt lock holds even heavy Chimeras. Learn More

ARRI continues to broaden their LED line and reaffirm their commitment to accurate color rendering with the introduction of the SkyPanel S60-C LED Softlight. Supported by a steel yoke, the panel surface area measures 25.4 x 11.8" and employs interchangeable thermoplastic diffusers that range from Lite to Heavy to soften the light and wrap its output around your subject. The SkyPort outputs the equivalent of a 2000W tungsten soft light while drawing a maximum of only 450W. Using technology originally designed for the L7-C Fresnel, the SkyPanel S60-C can be adjusted to output a warm 2800K to icy blue 10,000K light and also uses the full RGB+W color gamut with hue and saturation control for fine adjustments. Full Minusgreen to Full Plusgreen is also possible, so if you're lighting for blue or greenscreen, you can simply dial in your chosen color. This wide degree of control is responsible for a high CRI of 95 and a rating of 90 with the newer TLCI standard. All of these functions as well as 0-100% dimming can be adjusted locally with the SkyPanel's onboard controller or remotely via DMX or a LAN. Besides inputs and outputs appropriate to these functions, the light also has a USB-A port for downloading firmware upgrades from a thumb drive or any PC/Mac. The SkyPanel S60-C can be used worldwide thanks to its included 90-250 VAC power supply, but it can also use optional 23-36 VDC batteries when mains power is unavailable. Besides the power supply, the light comes with a Junior (1 1/8") pin and a standard diffuser. This version of the light has a pole operated yoke and comes with a bare ends power cord. Learn More

. Learn More

. Learn More

Orbiter Color-Tuneable LED Light Open-Face Optics, Weatherproof 6-Light Spectra Color Engine Smooth 100 to 0% Dimming, Wireless DMX LiOS Light Operating System Power with 48V 3-Pin XLR Battery Input Quick Lighting Mount (QLM) Optional Dome and Open Face Optics Edison AC Power Connector Learn More

we have put together the L5-C LED Color Fresnel Kit in blue/silver to give cine and video productions the benefit of this powerful light source. The kit includes the L5-C Fresnel with a pole-operated yoke and a 5' powerCON TRUE1 Top mains cable with bare ends so that you can attach the plug you require. Learn More