ARRI

Light Aperture: 50.4 x 34.4" 4kW Tungsten Softlight Equivalent Full Gamut RGB+W Color Control Color Temperature: 2800-10000K Hue and Saturation Control Beam Angle: 105° Built-In LumenRadio CRMX Wireless DMX Wired & Wireless DMX with RDM Support Advanced Dynamic Effects and Programming Universal 90-250 VAC Power Supply Unit Learn More

LAMP HMI 1800 /SE OSRAM G38 SKU: 5302171 MFR: L2.37590.0 MODEL: L2.37590.0 Learn More

The Silver/Blue, Pole Operated L7-C LE2 Color LED Fresnel with powerCON Cable is part of ARRI's continuing effort to replace traditional Fresnels with powerful LED versions that offer unprecedented color control. The L7-C LE2 shares many characteristics with its predecessor, but the most obvious improvement is a 25% boost in power, increasing the light's tungsten equivalency from 750W to 1000W. This pole-operated version is meant for overhead mounting on pipe lengths or a grid. Pan, tilt, and focus are controlled from below with an optional pole using the 3 corresponding cups on the unit's special yoke. The key characteristic of any Fresnel is flood-to-spot capability, and the L7-C LE2 meets and exceeds expectations with an impressive beam angle of 15-50°. There's no learning curve when swapping out L7-C LE2 fixtures for fixtures with standard Fresnels. In fact, you're not going to be moving them around or juggling scrims in high places thanks to the 100 - 0% on-board dimming. The L7-C LE2 is a "fully tune-able" white light source too, allowing you to match existing fixtures from a warm 2800K to ice-blue 10,000K. The on-board controller allows manual intensity control as well as color temperature and +/- green. Specific color shades and skin tones can be matched through the full gamut color mixing feature. All functions can be controlled via DMX, an ideal feature for broadcast studios. The hybrid cooling system allows for cooling both actively (with a fan) or passively (without a fan) for times when the set needs to be dead quiet. The L7-C LE2's 1000W equivalent output draws only 160W during normal operation, making possible a savings of a 75% over similar output tungsten lights. And low heat means lower AC bills in the studio. You can actually run 9x L7-C LE2's from a 20A, 120VAC outlet as opposed to two 1000W or three 650W standard fixtures. Learn More

. Learn More

. Learn More

This is the Arri 8-Leaf Barndoor for the T1 Studio Fresnel. The barndoor set is constructed of a high strength-to-weight ratio metal which provides durability and resistance to bending. The four additional leaves swing forward, ensuring greater control of spill and tunneling of the light beam. Each leaf is user-tightenable. Learn More

Attaches Directly to the SkyPanel Includes 1/2 Grid Cloth Diffusion No Mounting Hardware Needed Learn More

ARRI L2.0033799 (L20033799) Cable for ARRI Orbiter Control Panel - 5m (16.4 ft). The control panel cable is not included in the control panel. It must be pruchased separately. Learn More

ARRI L2.0008064 Overview Dedicated to the ARRI SkyPanel S30 LED Softlight, this 60° Honeycomb Grid adds directionality to the light output and helps to control light spill by narrowing the beam angle to 60°. The grid slides into the S30's primary accessory slot and its honeycomb design also helps to reduce multiple shadows that traditional square louvers would create. Learn More